Selasa, 11 Januari 2011

power ampli car audio


power ampli car audio, auto radio, mobile audio, 12-volt and other terms are used to describe the sound or video system fitted in an automobile. While 12-volt audio and video systems are also used, marketed, or manufactured for marine, aviation, and buses, this article focuses on cars as the most common application. From the earliest days of radio, enthusiasts had adapted domestic equipment to use in their cars. In the 1960s, tape players using reel to reel equipment, Compact Cassettes, and then 8-track cartridges were introduced for in-car use.

A stock car audio system refers to the OEM application that the vehicle's manufacturer specified to be installed when the car was built. A large after market industry exists where the consumer can at their desire replace many or all components of the stock system. In modern cars, the primary control device for an audio system is commonly referred to as a head unit, and is installed in the center of the dash panel between the driver and the passenger. In older vehicles that had audio components as an option, such devices were mounted externally to the top of or underneath the dash. Car speakers often use space-saving designs such as mounting a tweeter directly over a woofer or using non-circular cone shapes. Subwoofers are a specific type of loudspeaker for low frequency reproduction. Extremely loud sound systems in automobiles, which have been nicknamed "boom cars", may violate the noise ordinance of some municipalities.

Motorcycles have been utilized with similar equipment since they also have the so-called "car audio" experience. Even pedal bicycles, as well as homemade boomboxes have utilized sealed lead-acid batteries (or 12V power supplies) for applications outside of motor vehicle use, likewise the store displays which mount in demo models prior to aftermarket purchases for installation.

The audio amplifier was invented in 1909 by Lee De Forest when he invented the triode vacuum tube. The triode was a three terminal device with a control grid that can modulate the flow of electrons from the filament to the plate. The triode vacuum amplifier was used to make the first AM radio.

Early audio amplifiers were based on vacuum tubes (also known as valves), and some of these achieved notably high quality (e.g., the Williamson amplifier of 1947-9). Most modern audio amplifiers are based on solid state devices (transistors such as BJTs, FETs and MOSFETs), but there are still some who prefer tube-based amplifiers, due to a perceived 'warmer' valve sound. Audio amplifiers based on transistors became practical with the wide availability of inexpensive transistors in the late 1960s.

Historically, the majority of commercial audio preamplifiers made had complex filter circuits for equalization and tone adjustment, due to the far from ideal quality of recordings, playback technology, and speakers of the day.

Using today's high quality (often digital) source material, speakers, etc., such filter circuits are usually not needed. Audiophiles generally agree that filter circuits are to be avoided wherever possible. Today's audiophile amplifiers do not have tone controls or filters.

Since modern digital devices, including CD and DVD players, radio receivers and tape decks already provide a "flat" signal at line level, the preamp. is not needed other than as volume control. One alternative to a separate preamp is to simply use passive volume and switching controls, sometimes integrated into a power amp to form an "integrated" amplifier.

1 komentar:

  1. nice blogs
    WE BELIEVE in breathing deep and slow. Knowing that every breath of fresh air we take restores life, filling us with energy, health, strength, and serenity. Fighting fatigue and fear as we clear the mind, invigorate the spirit and rejuvenate the skin to awaken the natural beauty within us all.

    BalasHapus